CLS - Interactive Owner's Manual

Where will I find...?

Warning triangle

Warning triangle
  

Remove warning triangle .

Setting up the warning triangle

Retainer
Side reflectors
Feet
  

Fold feet down and out to the side.

  

Pull side reflectors  upwards to form a triangle and lock them at the top using retainer .

 

First-aid kit

Check the expiry date of the first-aid kit annually, and replace the contents if necessary.

Handle
  

To open: pull handle up.

  

Fold the cover forwards.

  

Remove the first-aid kit.

 

Fire extinguisher*

Have the fire extinguisher refilled after each use and checked every one or two years. Otherwise, it may fail in an emergency.

Observe the legal requirements in all countries concerned.

Handle
  

To open: pull handle up.

  

Fold the cover forwards.

  

Remove the fire extinguisher.

 

Vehicle tool kit, jack and spare wheel*

The vehicle tool kit is located in a stowage compartment underneath the boot floor.

Risk of injury

The jack is designed only to raise and hold the vehicle for a short time while a wheel is being changed.

If you are carrying out work on the vehicle, you must use stands.

Make sure that the jack is placed on a firm, non-slip and level surface. Do not use wooden blocks or similar objects as a jack underlay. Otherwise, the jack will not be able to achieve its load-bearing capacity due to the restricted height.

Do not start the engine at any time while a wheel is being changed.

Do not lie under the vehicle when it is being supported by the jack. If you do not raise the vehicle as described, it could slip off the jack (e.g. if the engine is started or a door or the boot lid is opened or closed) and you could be seriously injured.

When using the jack, you should also observe the safety notes in the "Flat tyre" section more.

  

Fold up the boot floor and hook the retainer into the top of the boot frame.

Vehicles with a TIREFIT kit

Vehicle tool kit, jack, warning triangle
Electric air pump
TIREFIT kit

Vehicles with "Minispare" emergency spare wheel*/collapsible emergency spare wheel* or a spare wheel

Vehicle tool kit, wheel wrench, jack
"Minispare" emergency spare wheel* or spare wheel*
Fastening element
Removing the "Minispare" emergency spare wheel*/collapsible emergency spare wheel or spare wheel*
  

Remove the luggage well more.

  

Turn fastening element  anti-clockwise.

  

Remove "Minispare" emergency spare wheel* or spare wheel* .

Removing or fitting the luggage well

Securing clips
Luggage well
  

To remove: unscrew securing clips  from the securing bolts by turning the clips anti-clockwise.

  

Lift up luggage well in the area of securing clips .

  

Remove luggage well from the boot.

  

To fit: insert the luggage well into the boot in such a way that securing clips  are roughly aligned with the securing bolts.

  

Press the front edge of the luggage well under the trim of the loading edge in the direction of the arrows.

  

Press securing clips  up to the stop against the securing bolts.