Interactive Owner's Manual [In depth | Where will I find...?]

Date of printing:

11/23/2009

Owner's Manual version: RE 2009/09a

Note: The online Owner's Manual is the latest version available. Deviations between this manual and items specific to your vehicle may occur since Mercedes-Benz constantly adapts its vehicles to the latest technology and modifies design and equipment. Please note that this online Owner's Manual does not under any circumstances replace the printed Owner's Manual which is supplied with the vehicle.

Where will I find...?

Quick access

Vehicle tool kit, "Minispare" emergency spare wheel*, spare wheel*

Warning triangle

	Turn lever 90° in the direction of the arrow.
	Remove warning triangle .

Setting up the warning triangle

	Fold feet down and out to the side.
	Pull side reflectors up to form a triangle and lock them at the top using press-stud .

First-aid kit


Check the expiry date of the first-aid kit annually, and replace the contents when necessary.

	Release Velcro fastener .
	Remove first-aid kit from the luggage net.

Fire extinguisher*

Have the fire extinguisher refilled after each use and checked every one or two years. Otherwise, it may fail in an emergency.

Observe the legal requirements in all countries concerned.

	Pull handle upwards.
	Pull cover forwards in the direction of the arrow.
	Remove the fire extinguisher from the stowage compartment.

Vehicle tool kit, "Minispare" emergency spare wheel, spare wheel

The vehicle tool kit, spare wheel, etc. are located in the stowage well under the boot floor.

The vehicle tool kit contains:

TIREFIT kit
electric air pump
towing eye
spare fuses

Vehicles with a "Minispare" emergency spare wheel*/spare wheel* have additional wheel changing tools, consisting of:

folding wheel chock
jack
centring pin
wheel wrench
one pair of gloves

Risk of injury

The jack is designed only to raise and hold the vehicle for a short time while a wheel is being changed.

You must use stands if you are carrying out work on the vehicle.

Make sure that the jack is placed on a firm, non-slip, level surface. Do not use wooden blocks or similar objects as a jack underlay. Otherwise, the jack will not be able to achieve its load-bearing capacity due to the restricted height.

Do not start the engine at any time while a wheel is being changed.